Break time not working??

Post Reply
jkaplan
Posts: 2
Joined: Sat May 29, 2021 8:37 pm

Break time not working??

Post by jkaplan » Sat May 29, 2021 8:46 pm

I'm trying to set a MINIMUM clip length of 30 seconds after motion is detected.

For each camera I set a "break time" of 30 seconds on the Trigger tab of its settings.

No luck - it regularly cuts off far earlier than 30 seconds.

Any hints as to why would be greatly appreciated.

See attached screenshots.

Version info: 5.4.6.4

Any leads would be greatly appreciated!

Jerry
Attachments
Short clips.jpg
Short clips.jpg (115.17 KiB) Viewed 329 times
Carport trigger settings.jpg
Carport trigger settings.jpg (204.18 KiB) Viewed 329 times
Post Reply