add pelco camera

Post Reply
dturnball
Posts: 1
Joined: Tue Jul 09, 2019 1:17 pm

add pelco camera

Post by dturnball » Wed Jul 17, 2019 3:20 pm

I am trying to add Pelco IP cameras to my Blue Iris version 4.8.6.1 and also to a new version 5 system. I could get them to come on right at first using the "Pelco" option under "Make" and then selecting the "Sarix, Spectra IV RTSP" option under Model. But it only gets a signal from the camera for a short time then goes to a "No Signal" error and I can never get the video back. Is there a way to correct this?

Post Reply