Page 1 of 1

Switch on monitor at motiondetection

Posted: Wed Jun 17, 2020 12:01 pm
by PlopDK
Hi all
Is it possible, to get Blue Irsh 4 to get the monitor out off powersaving mode at motion detection ?
Maybe fire a short script that gets windows to send the power on signal to the monitor ?

Re: Switch on monitor at motiondetection

Posted: Sat Jun 27, 2020 4:33 pm
by MikeBwca
I use Nirsoft's 'Nircmd' to put my monitors to sleep. It can also do a lot more, like positioning. It's possible you could set it to position the cursor, which should wake up the monitors.