It's nuts there is no way to reset settings without blowing out the product license too. Why wouldn't they just use a config file?! Anyways I followed this on mine and my key worked to reactivate a second time on the same machine. YMMV

MikeBwca wrote: ↑Fri Dec 20, 2019 7:54 am The only thing I can think of is if the drive is going to sleep, and needs to wake up.

You could try changing to 'Continious' to test.

You think even on an SSD this would happen?

MikeBwca wrote: ↑Fri Dec 20, 2019 12:16 am Keep increasing the Pre-trigger to see what happens. Try 15.

Also, When using 'When Triggered', when you have 'Combine or cut...' enabled, it will join all clips into one. Unselect this option, and these triggered clips will appear individually.

What is your make time?

MAKE time is 0.1 sec

MikeBwca wrote: ↑Thu Dec 19, 2019 5:29 pm Could you post an screen capture of the 'Record' settings?

Manually trigger thru the menu. Does the same thing happen?

Attached is my record tab. See anything odd?

I am having an issue where I sometimes see a delay between the alert image and the actual start of the recording clip. If I blow up the Alert Image I can see the camera time stamp of 9:43:45 with an animal in my yard. My recording didn't begin though until 9:43:58 which is 13 seconds later. I have m...

No one?

Did the OP ever find a solution to this? Did a new update fix it?

I have been trying to get an older Foscam model# 8919w to work with Blue Iris 5. I used the auto-detect by putting in the camera's IP as well as the admin port :8090 after. BI went out, auto detected the camera make and model correctly and al looked like I was good. After clicking Ok to add the came...